BLS-125AWB [$199.99-]
8.4V@126.5kg/1757.1oz
8.4V@0.15sec
※ We have two option versions:
This one is the Dual-wire version. The accessory has an additional power supply wire that can be used directly from the lithium battery to get the necessary power.
DETAILS
Application / Suitable
| 1/4、1/5th Scale Vehicles, such as Buggy ( Off-Road ), GT ( On-road ), Monster Truck, Rock Crawler & Large Boats, etc. |
Specifications
| Stall Torque At 6.6V |
99.5 kg-cm / 1382.1 oz-in |
| Stall Torque At 7.4V |
111.4 kg-cm / 1547.3 oz-in |
| Stall Torque At 8.4V |
126.5 kg-cm / 1757.1 oz-in |
| No-load Speed At 6.0V |
0.19 sec / 60° |
| No-load Speed At 7.4V |
0.17 sec / 60° |
| No-load Speed At 8.4V |
0.15 sec / 60° |
| Stall Current At 6.0V |
11.7 Amp |
| Stall Current At 7.4V |
13.5 Amp |
| Stall Current At 8.4V |
15.4 Amp |
Protection Mechanism
| Soft Start Protection |
Soft start back to a neutral position. |
| Over Voltage Protection |
Over 9.0V drive the protection mode, and 8.7V return to normal mode. |
| Low Voltage Protection |
Lower than 5.8V, drive the protection mode, and 6.0V return to normal mode. |
| Locked Rotor Protection |
Stall in 3 sec, output torque goes down. |
| Temperature Protection |
Overheat 85 degrees C (185 degrees F), drive the protection mode and down 75 degrees C (167 degrees F) return to normal mode. |
| Lose Control Protection |
When losing the transmitter signal, that servo will immediately be back to the neutral position and locked. |
Power Supply
| Operating Voltage Range |
6.0V ~ 8.7V ( 2S Li-Fe / 2S Li-Poly HV ) |
| Operating Temperature Range |
-20°C ~ +60°C ( -4°F ~ +140°F ) |
Control Specification
| Control System |
Higher-order Algorithm of【STMicroelectronics】32-bit MCU
AD 12-bit Resolution ( 4096 Steps )
Frequency：Up to 400Hz & 1500us or 1520us |
| Frame Rate (Signal repeat rate) |
Under 1ms【Auto-adaptive with Futaba_UR/SR & Sanwa_SXR & KO_HCS Mode】 |
| Dead Band Width |
0.002ms ( Default：2us) |
Mechanical Specifications
| Ball Bearing |
Dual, Stronger Ball Bearings with 1 piece of oil seal.【NMB from Japan】 |
| Gear |
Stainless Steel Output Gear With All Steel Gears |
| Motor |
High-Efficiency Brushless Motor |
| Outside Case |
Full Aluminum Alloy Case |
| Horn / Gear Spline |
15 Teeth ( Universal Type ) |
| Connected Cable Length |
300 mm (11.81 in) [ TYU : Black w/ Gray & JST : Red w/ Black ] |
| Connected Housing |
Universal Connector [ Black ] + JST Connector [ Red ] |
| Ingress Protection Rating |
IP67 means: 6=Dust Tight / 7=Immersion up to 1 Meter depth of 30 minutes |
Physical Specifications
| Dimension (mm) |
65.8 x 30 x 56.5 mm / 2.59 x 1.18 x 2.22 in |
| Weight (gram) |
229.0 ± 1 grams / 8.08 oz W/O Cable |
| Product Picture / Dimension Sketch |
-2.png) |
